Issues after Password Encryption

Raise/discuss any potential issues with MailEnable for consideration in project issue register.
Post Reply
MartynK
Posts: 1364
Joined: Sat Dec 28, 2002 1:12 am
Location: Hong Kong

Issues after Password Encryption

Post by MartynK » Thu Jun 25, 2015 2:36 pm

I enabled password encryption today after speaking with a couple of my users.

All seems to work great for the basic services but webdav and caldav dont take up the new settings.

I had to reboot to get webdav and caldav to start working again.

Should the "enable" process not sort this issue ?

MailEnable-Ian
Site Admin
Posts: 9247
Joined: Mon Mar 22, 2004 4:44 am
Location: Melbourne, Victoria, Australia

Re: Issues after Password Encryption

Post by MailEnable-Ian » Fri Jun 26, 2015 12:22 am

Hi,

I would of thought the password encryption procedure would have restarted the "Synchronization (MEHTTPS.EXE)" service after encrypting the passwords. Perhaps this didn't happen. Did you try to restart the synchronization service before restarting the server?
Regards,

Ian Margarone
MailEnable Support

MartynK
Posts: 1364
Joined: Sat Dec 28, 2002 1:12 am
Location: Hong Kong

Re: Issues after Password Encryption

Post by MartynK » Fri Jun 26, 2015 12:58 am

No I must admit I did not, as I was not sure what it was and no services where stopped from what I could see, hence the reboot.

MailEnable-Ian
Site Admin
Posts: 9247
Joined: Mon Mar 22, 2004 4:44 am
Location: Melbourne, Victoria, Australia

Re: Issues after Password Encryption

Post by MailEnable-Ian » Fri Jun 26, 2015 1:12 am

HI,

Yeah my guess is that the sync service wasn't restarted. Ill check with the devs on my side to see if this is the case and raise an issue if need be. Just keep in mind for next time I suppose to restart all services manually.
Regards,

Ian Margarone
MailEnable Support

Post Reply