moving MailEnable STD fromVM to another VM -not working

Discussion regarding the Standard version.
Post Reply
newcomer01
Posts: 2
Joined: Wed Dec 12, 2018 2:17 pm

moving MailEnable STD fromVM to another VM -not working

Post by newcomer01 »

Dear All,

I have been using the MailEnable STD V8.51, it was working fine during 3 years by installed it on my a VM (hyper-V).

Now I did a clone of this VM MailEnable to another hyper-V host, and create a new domain and re-configure it accordingly.

I try to telnet my MailEnable by port 110/25 from my client -all is good result, but it always asking the "enter the username and password for the following server"error popup whenever I try to configure an email account by MS outlook client.

I am sure the username,password, IP of EnableMail are corrected information.

So could you please advise what I am wrong?
Many Thanks

newcomer01
Posts: 2
Joined: Wed Dec 12, 2018 2:17 pm

Re: moving MailEnable STD fromVM to another VM -not working

Post by newcomer01 »

hi 4rum,

Pls ignore my question, since I have solved this by re-install the later version MailEnable.

Anyway Thanks

Post Reply