Hi,
I have mailEnable standard version 9.0
I want to keep all mailbox email hence trying to set rule and found online to use this utility
I copied it to bin folder and started exe
Set domain cuz.com for whose post office all emails I want to copy
I created mailbox in its post office and set as mailbox
Restarted server too but still mails are not getting copied.
Can you suggest what is problem ?
MESNOOP utility not working
-
- Site Admin
- Posts: 1127
- Joined: Mon Jun 10, 2002 6:31 pm
- Location: Melbourne, Victoria, Australia
Re: MESNOOP utility not working
Hi,
Are you running it as an administrator? Look at the MTA settings in the administration program, as when you save the settings it should have added and enabled a pickup event. If you run the MESNOOP program again it should load the previous settings, if not then it is likely it was not run as an administrator.
Are you running it as an administrator? Look at the MTA settings in the administration program, as when you save the settings it should have added and enabled a pickup event. If you run the MESNOOP program again it should load the previous settings, if not then it is likely it was not run as an administrator.
-
- Posts: 5
- Joined: Sat Nov 30, 2019 4:13 pm
Re: MESNOOP utility not working
Thanks.
Earlier I did not run as administrator, but today I ran executable as administrator. Set properties but I am not able to see anything in MailEnable Console. Only Logs option is available, not other rules. When I check the latest activity log it says "System Default Route Applied" for forwarding I had set from Plesk.
This is what I am trying to do
I have postoffice domain
A.com
mailbox: a
mailbox: b
mailbox: archive - where I want to copy all incoming and outgoing mails from a, b
In MESNOOP I select
Copy Mail Containing, specify A.com (as domain)
PostOffice Name: A.com
Message Filtering: On
MailBox Name: archive
Hope this is doable.
Please suggest if I am missing anything or looking at the wrong place as I do not see the pickup event.
Earlier I did not run as administrator, but today I ran executable as administrator. Set properties but I am not able to see anything in MailEnable Console. Only Logs option is available, not other rules. When I check the latest activity log it says "System Default Route Applied" for forwarding I had set from Plesk.
This is what I am trying to do
I have postoffice domain
A.com
mailbox: a
mailbox: b
mailbox: archive - where I want to copy all incoming and outgoing mails from a, b
In MESNOOP I select
Copy Mail Containing, specify A.com (as domain)
PostOffice Name: A.com
Message Filtering: On
MailBox Name: archive
Hope this is doable.
Please suggest if I am missing anything or looking at the wrong place as I do not see the pickup event.
- Attachments
-
- MailEnable.png (7.52 KiB) Viewed 12607 times