Different values in headers for different domain names

Discussion regarding the Standard version.
Post Reply
tim.nbj
Posts: 9
Joined: Sun Sep 28, 2014 8:38 am

Different values in headers for different domain names

Post by tim.nbj » Mon Dec 21, 2020 2:10 pm

Hi Everyone

On the "General" tab of the SMTP properties box, there are two boxes entitled "Local domain name" and "Default mail domain name". I have discovered that whatever you put in those two boxes ends up in the headers of emails you send using the MailEnable SMTP relay. This gives the same values in the headers for all of the domain names you have defined in the "Post Offices" section. I am not sure of a clearly understandable way of asking this but Is there a way of giving each domain name in the "Post Offices" section there own values for these two boxes so that for each domain name in the "Post Offices" section, different values end up in the headers of emails sent using the MailEnable SMTP relay? (according to the domain name in the "From" header in the email being sent)

I hope you can understand the above question.

Thank you very much.

Kind regards

Tim

MailEnable-Ian
Site Admin
Posts: 9400
Joined: Mon Mar 22, 2004 4:44 am
Location: Melbourne, Victoria, Australia

Re: Different values in headers for different domain names

Post by MailEnable-Ian » Mon Dec 21, 2020 10:50 pm

Hi,

You can only configure this using Postoffice IP bindings which is an exclusive feature to the Enterprise edition.
Regards,

Ian Margarone
MailEnable Support

tim.nbj
Posts: 9
Joined: Sun Sep 28, 2014 8:38 am

Re: Different values in headers for different domain names

Post by tim.nbj » Tue Dec 22, 2020 9:45 am

Hi Ian

Thank you very much for your reply.

Kind regards

Tim

Post Reply